Kinook Software Forum

Kinook Software Forum (https://www.kinook.com/Forum/index.php)
-   [VBP] General Discussion (https://www.kinook.com/Forum/forumdisplay.php?f=2)
-   -   Set Next Statement command (https://www.kinook.com/Forum/showthread.php?t=5130)

deramor 02-14-2013 05:59 PM

Set Next Statement command
 
I find that while debugging, I need to run a small section of a build a few times to test it. In order to rerun the section, I need to get the next statement arrow to move. I usually get this to move by running a step prior to the section I want to debug then stepping through my new steps.

I know in Visual Studio debuggers, they allow you to set the next statement that gets executed. Is it possible to do this here as well? Maybe not while a build is running/paused. Even having the ability to move the pointer when the build is stopped is a benefit.

kinook 02-14-2013 08:02 PM

See the Build from Cursor / Start from Cursor commands, or Rebuild Step Group.
http://kinook.com/VisBuildPro/Manual...ofbuilding.htm


All times are GMT -5. The time now is 08:40 AM.


Copyright © 1999-2023 Kinook Software, Inc.