View Single Post
  #22  
Old 03-07-2007, 01:12 PM
Leoram Leoram is offline
Registered User
 
Join Date: 08-03-2005
Posts: 119
The problem of "read only" you have might've emerged from the fact that you could probably have the urd file properties set to "read only" before you imported it. In that case you need to go back and do a re-import of the physical file from the explorer (but change the read only condition first, by doing a right-click, properties over the file).

Your point on the URL that you mentioned is irrelevant. In my case I just used a physical copy of my urd and not the original. The URL address can vary depending on what the file was and where the user imported it from.

My version is now 3.0 as I upgraded yesterday, but I tested what we are dealing with and everything is OK.

If you have Store and also Link is because you already have a copy of the urd file you imported. Once you delete the file from the original place on the disk the link thing will disappear.

Hope this one helps .
Reply With Quote