|
#1
|
|||
|
|||
Store exit code in temporary macro
I would like to be able to store the exit code of the program command in a temporary macro during a build step.
This is so I can decide, based on the exit code whether to execute a future step. For example, an installation returns with code 3010 to signal the install succeeded, but a reboot is required. I have added this exit code to the Success exit codes which is fine, but I think I need to set the temp macro to the exit code value in the post step event. Is this possible? |
#2
|
|||
|
|||
Either
1) In the step's vbld_StepDone script event, store the value like so: Code:
vbld_TempMacros.Add "TEMP_EXIT_CODE", vbld_TempMacro("RUNPROGRAM_EXITCODE").Value http://www.kinook.com/VisBuildPro/Ma...gramaction.htm http://www.kinook.com/VisBuildPro/Ma...scriptmisc.htm or 2) Add a Set Macro step following the step that runs the program and set a temp macro's value to %RUNPROGRAM_EXITCODE% http://www.kinook.com/VisBuildPro/Ma...acroaction.htm |
#3
|
|||
|
|||
Thanks very much
|
Tags |
exit code macro |
|
|