|
|
|
|
#1
07-08-2008, 08:08 AM
|
|||
|
|||
|
ClearCase rebase
Hi,
I'm trying to run a ClearCase step to rebase to a set of baselines that isn't recommended. I'm using the -baseline option, but can't seem to get the syntax right when specifying more than one baseline. I tried -baseline [baseline1, baseline2, baseline3, ...] with both square and curly brackets to no avail. I've also tried putting the @VOBselector after each baseline. Again, no luck. Any ideas? 
|
|
#2
07-08-2008, 08:17 AM
|
|||
|
|||
|
|
|
#3
07-08-2008, 08:41 AM
|
|||
|
|||
|
I've looked at their syntax block but still can't get it to work right. Also, if I don't use the -baseline option but instead list the baselines in the "Baselines:" box on the "Rebase" tab, I get the following:
cleartool: Error: Unrecognized option "-baselines"
|
|
#4
07-08-2008, 10:12 AM
|
|||
|
|||
|
The ClearCase action incorrectly uses -baselines instead of -baseline for the Baselines field. That will be fixed, but for now you can work around the problem by using the Additional command-line options field on the Options tab instead.
As far as the specific syntax for what you're trying to do, if the links mentioned don't help, log a support ticket with IBM/Rational support for questions about cleartool syntax.
|
 |
|
|
Hybrid Mode
