Failure Steps are not being executed

[mdoepker]

I have a single failure step defined that will send an E-mail to the group when a build fails. I have tried numerous steps and can not get the Failed Steps to be executed when running from the Projects Steps tab.

If I go to the Failure Steps tab and then execute the step directly from there by selecting "Rebuild Selected" the E-mail will be sent no problem.

I have the 'Build failure steps' checked but when I assign the Failure step specifically or leave it blank so that it is supposed to run all failure steps, then I'm getting no e-mail notification.

I have created a simple Project Step (vbscript) that will fail everytime and I cannot get it to run the failure step.

Version is 6.1

Thanks
--Mark