|
#1
|
|||
|
|||
Is there a way to continue to loop given the value of a macro? Loop is limited by count or file contents but not a conditional statement.
Perhaps using the General tab to execute the step according to an expression. Then loop on a count so it doesn't run off forever. The resulting logic roughly would be: if(expression == TRUE && count < maxNumberOfLoops) do the loop endif Thoughts? |
#2
|
|||
|
|||
You can use the Exit action to end a loop.
https://kinook.com/VisBuildPro/Manual/exitaction.htm Or you can use a repeating build rule instead of a Loop action. https://kinook.com/VisBuildPro/Manual/buildrules.htm |
|
|