vbld_StepDone fails,build does not continue

[teognost]

I have a step where "Continue building" checkbox is ticked.
So if the step fails -the build continues.For this step in ScriptEditor I have implemented some code for vbld_StepDone event.
Problem is -if this code fails-the build process is stopped despite of the "Continue building" set to TRUE.
As I see in the comments of vbld_StepDone -this is normal:
' If the step is marked to ignore failure, throwing or raising an error
' or calling Builder.Stop from this event will not ignore the failure
' (providing a way to abort the build even when the step is marked to
' ignore failure).
Question -is there any way to avoid this?
I mean even if the code in vbld_StepDone fails for some reason-the build process to contine.

[kinook]

Eat the errors (On Error Resume Next in VBScript, try { ... } catch(err) { } in JScript).

[teognost]

I added
On Error Resume Next
immediately after
Sub vbld_StepDone()
so the build continues but i do not see any error message.
I would need a way to see the error message and to trigger the failure step but to have the build continued with next step.

[kinook]

See attached sample (assumes VBScript is default scripting language).

[teognost]

Tks!
so the code :
' check failure and mark step as failed if so
If Err.Number <> 0 Then
Builder.LogMessage Err.Description
Step.BuildStatus = vbldStepStatFailed
End If
could stay only once at the end of the subprocedure,it is not necessary to write it after any operation that could fail.

[kinook]

Yes, as long as Err is not cleared.